beautypg.com

CITIZEN CBM-270 User Manual

Page 9

background image

CBM-270 User’s Manual

CITIZEN

9

P

PP

PR

R

R

RE

E

E

EC

C

C

CA

A

A

AU

U

U

UT

TT

TIIIIO

O

O

ON

N

N

NS

S

S

S F

FF

FO

O

O

OR

R

R

R IIIIN

N

N

NSSSST

TT

TA

A

A

ALL

LL

LL

LLA

A

A

AT

TT

TIIIIO

O

O

ON

N

N

N

· Do not use or store the equipment in a place exposed to fire, moisture, or direct sunshine,

or in a place near a heater or thermal device where the prescribed operating temperature

and humidity are not met, or in a place exposed to much oil, iron powder, or dust. The

equipment may become out of order, emit smoke, or catch fire.

· Do not install or use the equipment in a place like a laboratory where chemical reactions

are expected, or in a place where salt or gases are contained in the air. There is a danger

of fire or electric shock.

· Install the printer on a flat, stable desk or table that is free from vibration, in a well-

ventilated place.

· Do not install the printer at a location where its operation could be hindered.

· Do not place anything on the printer or leave small objects, like a clip or pin, around it. A

foreign object could cause trouble if it gets inside.

· Do not use any sharp-pointed object, such as a pen, for example, to touch the operation

panel of the printer. It could cause trouble.

· Do not use the equipment near a radio or TV receiver. Do not share the power from a plug

socket a radio or TV receiver is connected to. It may cause a reception problem.

· Use the equipment only at the specified power supply, voltage and frequency. Otherwise,

it may emit smoke and catch fire or cause other problems.

· Connect only the specified power source. Use of an unspecified power source could cause

trouble or smoke/fire.

· Confirm that a plug socket used for connection has sufficient capacity.

· Avoid connecting a power cable to a plug socket shared by other devices or extending the

wiring too far. It may result in the cable catching fire or a power outage. Also, do not

step on or apply an excessive force (Pull, load) to the cable, and do not use the printer with

such a force applied to it.

· Never connect a grounding cable (Frame ground) to a gas pipe. There is a danger of

explosion. When connecting or disconnecting the grounding cable, be sure to disconnect

the power cable and the power plug from the plug socket.

· When connecting/disconnecting the cables, be sure to turn off the power first, including the

connected side, and then connect/disconnect them, holding a plug and a connector.

Pulling the cable itself could cause it to snap or become damaged.

· Connect a power cable or a connector cable securely. If a reverse-polarity connection is

made, internal elements may be broken or a mating device may be adversely affected.

· Use a shielding wire or twisted pair wire for a signal line, in order to minimize noise effect.

Do not route the cable too long or connect it to a noisy device. Connection to a noisy device

could cause erroneous printing due to corrupt data, and so on.

· Use the equipment in an environment where there is a plug socket near the main body and

you can easily disconnect the power plug from it, to shut off the power.

· When the equipment will not be used for a long period of time, unplug it and remove the

paper roll from it.

· When transporting the equipment, remove the paper roll from the paper holder.