CITIZEN CBM-270 - Manual (Page 88)

CBM-270 User’s Manual
CITIZEN 88
GS < (Only When Label Printer is Selected)
[Function] Initializing the printer mechanism
[Code] <1D>H<3C>H
[Outline] This command initializes the printer mechanism.
[Caution] This command is valid only when the label printer is selected with DS1-5. Since
it uses one label for scanning, a head search starts from the next label. The
maximum label length and label spacing (Black mark) is 300 mm. Any label
exceeding this limit results in an error.
GS A m n (Only When Label Printer is Selected)
[Function] Correctting the label top position
[Code] <1D>H<41>H
[Range] 0 £ m £ 255, 0 £ n £ 10
[Outline] This command sets the label head search position in terms of correction value for
the default position. m denotes the correcting direction and valid only for the
least significant bit (m0).
m 0 Correcting direction
0 Corrects in the forward direction
1 Corrects in the reverse direction
n denotes a correction value; it is set in increments of n/203 inch.
[Caution] This command is valid only when the label printer is selected with DS1-5. The
correction value remains valid until it is re-set with this command or the power is
turned on again. Any setting beyond the range is ignored.