Ram Trucks uconnect 8.4AN for Chrysler - Manual (Page 295)

Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting playlists,
play, fast forward, etc.) cannot be provided by the radio; use
the device controls instead. Adjust the volume with the
VOLUME & MUTE rotary knob, or with the volume of the
attached device.
NOTE: The vehicle radio unit is acting as the amplifier for
audio output from the Auxiliary device. Therefore if the
volume control on the Auxiliary device is set too low, there
will be insufficient audio signal for the radio unit to play the
music on the device.
Source
Touch the Source soft-key to select the desired audio source:
AUX. This screen will time out after a few seconds and
return to the main radio screen if no selection is made.
Audio
Refer to Radio Mode for adjusting the audio settings.
SD Card Mode — If Equipped
Overview
SD Card Mode is entered by either inserting a SD Card
into the SD Card slot or touch the SD Card soft-key on the
left side of the display. Once in Media Mode, touch the
source soft-key and select SD Card.
Seek Up/Down
Touch and release the right arrow soft-key for the next
selection on the SD Card. Touch and release the left arrow
soft-key to return to the beginning of the current selec-
tion, or to return to the beginning of the previous
selection if the SD Card is within the first second of the
current selection.
Browse
Touch the browse soft-key to display the browse window.
The left side of the browse window displays a list of ways
you can browse through the contents of the SD Card.
294 Uconnect® 8.4AN