Hudson Robotics PlateCrane EX - Manual (Page 39)

PlateCrane EX User Manual Hudson Robotics, Inc.
35
 Remove the blown fuse. Replace it with the spare fuse.
 Slide the fuse holder tray back into the AC inlet until it clicks. Make sure when re-
installing the holder the AC line voltage reads the correct way on the inlet
 Reconnect the power cord to the PlateCrane and reconnect all other cables
previously disconnected.
 Verify correct fuse replacement by turning the PlateCrane switch to ON position--
the light will illuminate immediately.
Figure 17
Location of fuse
holder tray