Switching ac line voltage 110vac/220vac – Hudson Robotics PlateCrane EX User Manual
Page 14

PlateCrane EX User Manual
Hudson Robotics, Inc.
10
Figure 11
6. Switching AC Line Voltage 110VAC/220VAC
The power supplies installed in the unit are switching power supplies. That means they
are able to handle both 110VAC and 220VAC without any changes to their configuration.
The Run the PlateCrane on 220VAC perform the following:
Make sure the unit is powered off
Install the power cord that is supplying the 220VAC
Turn on unit
There is no other setup for the PlateCrane after this.
1 – Power ON position
0 – Power OFF position
Fuse holder door
Teach Pendant plug