BMW 760Li Sedan 2008 - Manual (Page 80)

E
ve
ryth
ing un
de
r co
nt
rol
78
Resetting values
You can reset values for the average speed and
average fuel consumption:
1. Activate the relevant menu item and press
the controller.
2. Press the controller again to confirm your
selection.
This also resets the information currently
shown on the Info Display.
Entering a distance manually
1. Select "To dest." and press the controller.
2. Turn the controller to set the distance to the
destination.
3. Press the controller to save the setting.
The distance to the destination is automatically
predetermined when using the navigation sys-
tem route guidance, refer to page
144 .
Using voice command system
Trip computer
The trip computer can be used, e.g. for a vaca-
tion trip.
iDrive, for principle details, refer to page
16 .
1. Press the button to open the start
menu.
2. Move the controller toward "Car Data".
3. Select "BC " and press the controller.
> Departure time
> Driving time
> Distance traveled
> Average fuel consumption
> Average speed
To switch trip computer on/off and reset all val-
ues:
Select "START / RESET" and press the con-
troller.
To deactivate trip computer:
Select "STOP" and press the controller.
Service required
The distance or time period remaining until your
next service briefly appears when you switch on
the ignition.
Your Service Advisor will determine your
vehicle's current service requirements by
reading out the data stored in the remote con-
trol.
<
With BMW Assist enabled, information about
maintenance status of your vehicle or informa-
tion about legally mandated inspections is
automatically transmitted before the relevant
{ On-board computer } .
Online Edition for Part no. 01 41 0 013 316 - © 02/07 BMW AG