BMW 760Li Sedan 2008 - Manual (Page 114)

Practical interi
or
acc
ess
orie
s
112
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
You can operate the system when the engine is
running or when the ignition is switched on.
If the device cannot be used after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button
1 of the integrated universal
remote control. If the LED 2 on the integrated
universal remote control flashes rapidly for a
short time and then remains lit for approx.
2 seconds, then this indicates that the original
hand-held transmitter is equipped with an alter-
nating-code system. In the case of an alternat-
ing-code system, program the memory but-
tons
1 as described in the Alternating-code
hand-held transmitters section below. <
Alternating-code hand-held
transmitters
Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
the supplementary instructions below:
Programming will be easier with the aid of
a second person.
<
1. Park your vehicle within the range of the
remote-controlled device.
2. Program the integrated universal remote
control as described above in the Fixed-
code hand-held transmitters section.
3. Locate the button on the receiver of the
device you want to set up, e.g. on the upper
section of its drive unit.
4. Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
5. Press the programmable memory button 1
on the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any additional questions,
please contact your BMW center.
<
Deleting stored programs
Press the left and right memory buttons 1 for
approx. 20 seconds until the LED 2 flashes rap-
idly:
All stored programs are deleted.
It is not possible to delete individual programs.
Roller sun blinds*
Rear window blind
Briefly press the button on the driver's door with
the ignition in radio ready state or higher.
Roller sun blinds for rear side windows
1 Quarter window blind
2 Side window blind
3 Rear window blind
Online Edition for Part no. 01 41 0 013 316 - © 02/07 BMW AG