Cisco CIVS-IPC-2500 User Manual
Page 49
3-29
Cisco Video Surveillance System IP Camera User Guide
OL-14220-01
Chapter 3 Configuring and Managing the IP Camera
Applications Windows
If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
describes the options in the PTZ (RS-485) window.
Note
These features are not currently supported if you use the IP camera with Cisco VSM.
Table 3-18
PTZ (RS-485) Window Options
Option
Description
Enable External PTZ
Check this check box to enable configuration of the PTZ settings.
Port Settings
Baud Rate
Choose the Baud rate value that is configured on the device that controls the
PTZ functions of the IP camera.
Data Bits
Choose the data bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Parity
Choose the parity value that is configured on the device that controls the PTZ
functions of the IP camera.
Stop Bits
Choose the stop bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Address
Enter the logical address of the external PTZ device.
To determine this address, refer to the documentation for that device.
Preset Position
Note
The Preset Position option appears if you check the Enable External PTZ check box.
Set Preset Position
Click the Set Preset Position button to define a preset position of the IP
camera.
When you click this button, the Set Pan/Tilt window appears. For detailed
information about this window, see the