Formatting the phu-60k, Recording, Disconnecting the phu connection cable – Sony PMW-EX3 User Manual
Page 46: Secure the cable at the cable clamp, Turn on the phu-60k, Using the phu-60k, Prepa ra ti ons, Pass through the cable guide slot, Cable clamp, T120min stby stby a
![background image](/manuals/600891/46/background.png)
Using the PHU-60K
46
P
repa
ra
ti
ons
3
Pass the cable through the cable guide
slot above the card slot B and close the
cover.
4
Secure the cable at the cable clamp.
5
Turn on the PHU-60K.
The POWER indicator of the PHU-60K
lights in green.
Subsequently, the ACCESS lamp of the
camcorder lights in red then changes to green
once the unit is ready for use.
Disconnecting the PHU connection cable
Operate in the same manner as when you remove
an SxS memory card from the slot.
For a PHU-60K that is not formatted or that was
formatted with another system, a message to
confirm if formatting is to be executed is
displayed in the viewfinder.
Any PHU-60K formatted with a device other than
this camcorder cannot be used with the
camcorder.
To execute formatting
If the message for formatting is displayed,
turn the jog dial or tilt the joystick to select
“Execute” then press the dial or joystick.
Formatting begins.
An in-progress message and status bar (%) are
displayed, and the ACCESS lamp lights in red.
When formatting is completed, a completion
message is displayed for three seconds.
To format by menu operation
When no formatting message is displayed in the
viewfinder, you can execute formatting using
“Format Media” (page 128) of the OTHERS
menu in the same manner.
Notes
• Formatting for the PHU-60K on this camcorder
is “Quick Format” with which only the
managerial data are erased. To erase the
recording data completely, connect the unit to a
PC and perform “Full Format.”
• The PHU-60K to be used with this camcorder
must be formatted using the format function of
this camcorder. Any PHU-60K formatted with
another device must be formatted again with
this camcorder.
In Camera mode, the remaining capacity (in
minutes) of the PHU-60K connected via a card
slot is displayed in the viewfinder.
The available time for recording with the current
video format (recording bit rate) is calculated
according to the remaining space of the hard disk
and displayed in time units of minutes.
The remaining capacity can also be checked in a
meter format on the BATTERY/MEDIA status
screen (page 109).
Formatting the PHU-60K
SDI OUT
GE
TC IN
HDV
EL
PICTURE
PROFILE
CAMERA
OFF
MEDIA
AM
TO
PMW
-EX3
CH-1
AUT
O
MANU
AL
IN
EXT
AUT
O
MANU
AL
IN
EXT
CH-2
AUD
IO
LEV
EL
SLO
T S
ELE
CT
AUD
IO
SEL
ECT
AUD
IO
IN
A
B
OPEN
ACC
ESS
ASSIG
N
STOGR
AM
ATION
Pass through the cable guide slot.
SDI OUT
GE
TC IN
HDV
CH-1
AUT
O
MANU
AL
IN
EXT
AUT
O
MANU
AL
IN
EXT
CH-2
AUD
IO
LEV
EL
SLO
T S
ELE
CT
AUD
IO
SELE
CT
AUD
IO
IN
A
B
ACC
ESS
3
ASSIG
N
HISTOG
RAM
A
SHO
T
TRAN
SITIO
N
B
TC/U-BIT/DURA
TION
A
B
ACC
ESS
Cable clamp
Checking the Remaining Time
Available for Recording
T
120min
STBY STBY
A:
- - -
min
B: 185min
Z99