Dell POWEREDGE 2950 - Manual (Page 62)

62
Installing System Components
Figure 3-7. Installing a SATA Hard Drive and Interposer Card Into a SATAu Drive Carrier
Power Supplies
Your system supports one or two power supplies rated at an output of 750 W. If only one power supply is
installed, it must be installed in the left power supply bay (1). If two power supplies are installed, the
second power supply serves as a redundant, hot-plug power source.
NOTICE:
To ensure proper system cooling, the power supply blank must be installed on the unoccupied power
supply bay in a non-redundant configuration. See "Installing the Power Supply Blank" on page 65.
1 screws (4) 2 SATAu drive carrier 3 interposer card (SATA only)
4 SATA hard-drive 5 hole labels
SATAu SAS
1
4
5
3
2
Book.book Page 62 Friday, February 3, 2006 11:09 AM