Yealink SIP-T32G - Manual (Page 24)

User Guide for the SIP-T32G IP Phone
14
If your phone cannot contact a DHCP server for any reason, you need to configure a
static IP address manually.
To configure a static IP address via phone user interface:
1. Press Menu->Setting->Advanced Settings (password: admin) ->Network->WAN
Port->Static IP Client.
2. Enter the parameters: IP, subnet mask, default gateway, primary DNS, second DNS
in the corresponding fields.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. You can set a WAN port to be a PPPoE port. The PPPoE port will perform a PPP
negotiation to obtain the IP address. Contact your system administrator for the PPPoE
user name and password.
To configure PPPoE via phone user interface:
1. Press Menu->Setting->Advanced Settings (password: admin) ->Network->WAN
Port->PPPoE IP Client.
2. Enter the user name and password in the corresponding fields.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
Note Wrong network parameters may result in inaccessibility of your phone and may also
have an impact on your network performance. For more information on these
parameters, contact your system administrator.