Cooper Instruments & Systems MasterLink 3000 Wireless Load Cell Amplifier - Manual (Page 3)

CF 187 1 RevA
1.0 INTRODUCTION
The MasterLink 3000 is a stand-alone wireless strain gage device amplifier that is configurable to either a handheld
display, an analog output, or a USB interface.
The MasterLink 3000 software allows for the full configuration of the system. A spectrum analyzer allows the user
to determine an optimal channel selection and signal health can be monitored. A nine point direct input or applied
load calibration is setup through the software and USB device, giving maximum measurement linearity. Battery
voltage of the MasterLink 3000 can be monitored as well. Peak and valley conditions are inherently captured
utilizing the logging capability of the software.
SINGLE DEVICE OR SIMULTANEOUS COMMUNICATION CAPABLE
Handheld Display
USB
Analog Output