Cooper Instruments & Systems MasterLink 3000 Wireless Load Cell Amplifier - Manual (Page 19)

CF 187 17 RevA
In maximum Enter the input value that should result in the maximum
output. The maximum output depends on the Current
Selected Output which is determined by the SW2 DIP
switch settings.
Input value This shows the currently supplied value to the device.
An active acquisition module must be in place to
view this value.
Here you can set the action to take when certain errors occur.
The actions are applied when the errors occur and if more than one error is present the actions
are applied with the following priorities: Timeout Action, Remote Error Action, Remote Batt
Action
When errors are removed the analog output resumes reflecting the current input.