beautypg.com

Liquid fertilizer option – Great Plains PT8030 V1015 Operator Manual User Manual

Page 44

background image

42

Section 5 Maintenance and Lubrication

PT6030 and PT8030 Pull-Type Planter 401-032M-B

4/12/05

Great Plains Mfg., Inc.

Opener Disks, Scrapers and Gauge Wheels
1.

Lift side gauge wheel off ground. Move tire in and out
to check for end play. Check for roughness in bearing
by rotating wheel. If the bearings are rough, inspect
and replace if necessary.

2.

Remove side gauge wheels from arms to access
opener disks and scrapers.

Refer to Figure 5-8.

3.

With the unit raised, check blade spreader (1) for
wear. Replace spreader if it is 1/2 inch wide or narrow-
er. To replace, remove disk blade. Drive out roll pins
(2) and install a new spreader.

4.

Check disk blades (3) for wear.Replace blades if worn
to a diameter of 14 1/2 inches or less.

5.

When reinstalling disk blades, put two shims between
bearing and shank on one blade. Tighten bolt. On op-
posite side, reinstall blade with two (4) shims between
bearing and shank. Tighten bolt.

6.

Check contact point between disk blades. Place a
piece of paper in top gap between disks blades. Bring
paper down until it stops. In lower gap place another
piece of paper. Bring paper up until it stops. Measure
the distance between two pieces of paper. The dis-
tance must be between 1/2 and 1 3/4 inches. Add or
remove shims as needed to get the correct contact
point.

7.

Check that outside disk scrapers (5) are formed to
disk blades to help remove any mud. Bend and twist
scrapers to fit blades as necessary. After every 200
acres of planter operation, check outside scrapers for
proper adjustment and wear. Replace outside scrap-
ers as necessary.

17766

Figure 5-8

Opener Scrapers

Refer to Figure 5-9.

8.

Check for correct number of shims between side
gauge wheel (1) and wheel arm (2). There must be at
least one shim between wheel bearing and arm.
When installed, wheel should turn freely and not hit
arm at the curve. Do not add any more shims than
necessary.

9.

Disassemble side-gauge-wheel arm from row unit.
Remove bushing (3) from sleeve (4) and check bush-
ing for wear. Replace bushing if necessary.

10. When reinstalling side gauge wheels, align tab on hex

adjustment (5) with notch in bushing. Replace bolt and
tighten.

17791

Figure 5-9

Side Wheels

11. Adjust side gauge wheels. See Side Gauge Wheels,

Adjustments,” page 29.

Liquid Fertilizer Option

Although the tanks are made of a highly durable and cor-
rosion resistant plastic, proper maintenance is required.

Rinse tanks with water when changing from one solution
to another.

Rinse tanks thoroughly with water after each season or
before any shutdown lasting more than one week.

Do not allow sludge to accumulate in the bottom of the
tank.

Do not leave fertilizer in the tanks if the temperature is ex-
pected to drop below 40 degrees as some types of liquid
fertilizers will begin to crystallize at this temperature.

To clean tanks:

1.

Remove lids from tanks.

2.

Turn valve to elbow.

3.

After cleaning tanks, close shutoff valve, replace cap
on metering pump and replace lids on tanks.

This manual is related to the following products: