Great Plains 4336 DH Predelivery Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Table of Contents Index Assembly 21
05/22/2012 Table of Contents Index 556-100Q
Gauge Wheel
Refer to Figure 20
68. When light brackets are installed, unfold the disk and watch
that everything clears the brackets. Install the gauge wheel
assembly
(if applicable) with the 3/4 x 2 hex bolts , 3/4
lock washers and 3/4 nuts to wing frame as shown.
69. Tighten all bolts to specs, See “Torque Values Chart” on
page 24
70. Once the gauge wheels are in place, the assembly of the
disk harrow is complete. At this time the unit should be
checked over for any loose bolts. Air pressure in the tires
should be checked, See “Tire Inflation & Warranty” on
page 25. Refer to the lubrication section of the “Operators
Manual” for the lubrications for this machine. If there is any
rear attachment, it should be installed at this time.
C-Shank Alignment-Disc Gang Assembly
Refer to Figure 21
71. If gangs are removed from the gangbar for mainte-
nance, care must be taken to re-align the parts cor-
rectly during re-assembly. See figure below for the
proper C-shank alignment dimensions and pre
assembly procedures.
Figure 20
Gauge Wheel
41515
1
2
1 2
3
1
4
2
Figure 21
C-Shank Alignment-Disc Gang 41000