Great Plains 4336 DH Predelivery Manual - Manual (Page 12)

8 3323-4336DH Table of Contents Index Great Plains Manufacturing, Inc.
556-100Q Table of Contents Index 05/22/2012
Wide Center Frame Assembly
Refer to Figure 5
5.
Lower the left and right halves of the center
frame onto stands .
6. Install the bolts loose through the 4-hole tie plates
and center frames and with 1 x 8 hex bolts , 1
x 9 hex bolts , 1 lock washers and 1 nuts. Do not
tighten at this time.
7. Pin the LH and RH torque tube weldments to
the center frames with 1 1/4 x 8 3/4 pins (outer)
and 1 1/4 x 7 pins (center) (be sure nylon sleeves
are installed on pins). Secure pins with 3/8 x 2 1/4
Gr. 8 special thread bolts
and 3/8 top lock nuts.
8. Bolt on wide center fold bracket with four 1 x 8
hex bolts , 1 lock washers and 1 nuts, four 1 x 5 1/
32 x 6 1/2 u-bolts , four 3/4 x 2 1/2 hex bolts , 3/
4 lock washers and 3/4 nuts.
9. Fasten center lift cylinders , base end to center
frame and rod end to torque tube with 1 pins,
machine washers and cotter pins, provided.
10. Tighten all bolts to specs, See “Torque Values
Chart” on page 24.
1 2
3
4
1 2 5
6
7 8
9
10
11
12
5
13 14
15
U
D
F
B
L
R
5
Figure 5
Wide Center Frame 41001
2
6
5
1
4
4
9
13
3
14
14
8
7
10
12
15
11