ClearOne Musica Tools - Manual (Page 25)

PN: 020002 5-1
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Chapter
5
Controlling Keypads
Another benefit of MusicaTools is the ability to configure any Musica keypad attached
to the ADC from a central location. This chapter provides information on how to send
commands to a keypad.
NOTE: Once selections are made, they are applied to the keypad. No exporting feature
is needed.
The following steps allow you to change keypad settings
1. If you want to apply keypad settings across all keypads, select Global Command.
Continue to step 2.
NOTE: Global Command can copy settings from one keypad to keypads in each of up
to 18 zones.
2. From the MusicaTools interface, locate the room for the keypad you want to
program (see Figure 5-1).
Figure 5-1 Room 1 keypad (screen 1)
3. Enter information as described in Table 5-1.