Canon IMAGEFORMULA DR-2010M - Manual (Page 8)

4
Moving the Scanner
● When moving the scanner, always hold it with both hands to avoid
dropping it. The scanner weighs approximately 5.3 lb (2.4 kg).
● Make sure to disconnect the interface cable and AC adapter before
moving the scanner. If the scanner is transported with these items
connected, the plugs and connectors may be damaged.
Handling
WARNING
Note the following precautions whenever using the scanner. Failure to
do so may result in a fire or electric shock.
■ Never use alcohol, benzene, paint thinner, aerosol sprays, or any
other highly flammable substance near the scanner.
■ Do not cut, damage, or modify the power cord. Do not place heavy
objects on the power cord, and do not pull or excessively bend the
power cord.
■ Never connect the power cord when your hands are wet.
■ Do not connect the scanner to a multi plug power strip.
■ Do not knot or coil the power cord as this may result in a fire or
electric shock. When connecting the power cord, make sure that the
power plug is securely and completely inserted into the power
outlet.
■ Do not use a power cord or AC adapter other than the ones
provided with this scanner.
■ Do not take the scanner apart or modify it.
■ Never try to take the AC adapter apart or modify it in any way, as
this is dangerous.
■ When cleaning the scanner, turn the power switch OFF and
disconnect the power cord from the power supply.
■ Clean the scanner using a slightly dampened cloth which has been
well wrung out. Never use alcohol, benzene, paint thinner, or any
other flammable substances.
■ If the scanner makes strange noises, or gives off smoke, heat, or
strange odors, or the scanner does not function or other
abnormalities occur when you use the machine, immediately turn
the power switch OFF, and disconnect the power plug from the
power outlet. Then, contact your local authorized Canon dealer or
service representative for further information.
■ Do not drop the scanner, or subject it to impact or strong shock.
Should the scanner ever become damaged, immediately turn the
power switch OFF, and disconnect the power plug from the power
outlet. Then, contact your local authorized Canon dealer or service
representative to have the unit serviced.
■ Before moving the scanner, be sure to turn the power switch OFF,
and disconnect the power plug from the power outlet.
CAUTION
■ Do not install the scanner on a surface that is unstable or tilted, or
in an area subject to excessive vibrations, as this may cause the
scanner to fall, resulting in personal injury or damage to the
scanner.
■ Never place small metal objects such as staples, paper clips, or
jewelry on the scanner. These items may fall into the scanner, and
cause a fire or electric shock. Should such objects ever fall inside
the scanner, immediately turn the power switch OFF, and
disconnect the power plug from the power outlet. Then, contact
your local authorized Canon dealer or service representative to
have the unit serviced.
■ Do not install the scanner in a humid or dusty location. Doing so
might cause a fire or electric shock.
■ Do not place objects on top of the scanner. Such objects may tip or
fall over, resulting in personal injury.
■ Connect only to a power outlet of the rated voltage and power
supply frequency (120 V, 60 Hz or 220-240 V, 50/60 Hz depending
on your region).
■ When unplugging the power cord, grasp it firmly by its plug. Do not
pull directly on the power cord, as this may damage or expose the
cord’s internal wiring, resulting in a fire or electric shock.
■ Leave sufficient space around the power plug so that it can be
unplugged easily. If objects are placed around the power plug, you
will be unable to unplug it in an emergency.