Canon IMAGEFORMULA DR-2010M - Manual (Page 13)

9
Documents
The scanner can scan documents ranging in size from business cards
and checks to LTR/A4. The document sizes that this scanner can scan
are shown below.
Plain Paper
Size
Width: 1.97" to 8.5" (50 mm to 216 mm)
Length: 2.12" to 14.02" (53.9 mm to 356mm)*
Paper weight: (Page separation mode)
14 to 32 lb bond (52 to 128 g/m 2 ) 0.0024" to 0.0059" (0.06 mm
to 0.15 mm)
Paper weight: (Bypass mode)
11 to 42 lb bond (40 to 157 g/m 2 ) 0.002" to 0.0079" (0.05 mm to
0.20 mm)
* You can scan documents up to 39.2" (1000 mm) long by setting
the scanner to the Long Document mode. (See “Setting the Long
Document Mode” on page 24.)
IMPORTANT
A document must meet the following criteria to be scannable:
• When scanning multiple documents of different sizes, place the
documents so that they cover the entire span of the feed rollers.
• It is recommended that documents exceeding LTR, 11.69" (A4, 297
mm) size are fed one sheet at a time.
• Scanning documents before the ink is dry can cause problems with
the scanner. Always make sure that the ink on a document is dry
before scanning it.
• Scanning documents that are written in pencil or similar material
may make the rollers and scanning glass dirty, which can lead to
smudges on the scanned image and transfer the dirt to subsequent
documents. Always clean the internal parts of the scanner after
scanning such documents.
• When scanning a two-sided document that is printed on thin paper,
the image on the opposite side of each page may show through. In
this case, adjust the scanning intensity in the application software
before scanning the document.
• It is recommended that thin documents are fed one sheet at a time.
• Scanning the following types of documents can cause a paper jam
or malfunction. To scan such a document, make a photocopy of the
document and then scan the photocopy.
Business Card
Size: 1.97" x 2.12" (50 mm x 53.9 mm) or larger
Paper weight: 140 lb bond (300g/m
2
) 0.0138" (0.35 mm) or less
IMPORTANT
If a stack of business cards cannot be fed properly, reduce the
number of cards in the stack.
Card
Size: 2.12" x 3.37" (53.9 mm x 85.5 mm) (ISO/JIS
standard)
Card thickness: 0.03" (0.76 mm) or less
Orientation:
Horizontal feeding only
Embossed cards can be scanned.
CAUTION
• If you place cards to be fed vertically, they may not be ejected
properly, and cards that get jammed may be damaged when you
remove them. Take care of the orientation when placing cards.
• Embossed cards may not be able to be scanned correctly,
depending on the type of embossment.
Wrinkled or creased
documents
Carbon paper
Curled documents Coated paper
Torn documents
Extremely thin,
translucent paper
Documents with paper
clips or staples