Carrier MOTORMASTER 48/50P5030-100 User Manual

Page 7

REMOVE PANEL

RUN ELECTRICAL HARNESSES UP THE SIDE

OF THE UNIT IN THE SPACE BETWEEN THE

CORNER POST AND THE CONTROL BOX, THEN

ALONGSIDE THE WIRE TRAY. ROUTE

APPROPRIATE WIRES TO MOTORMASTER AND

OFM 3

MOTORMASTER

CONTROL

RUN TRANSDUCER HARNESS FROM CIRCUIT A

TRANSDUCER TO MOTORMASTER ALONG THE LENGTH OF

THE BOTTOM OF THE CONDENSER COIL THEN UP INTO

MOTORMASTER. RUN THE WIRES ALONG THE OUTSIDE

OF THE COIL TRAY.

Fig. 5 — MMV Control Mounting — 48/50P040 Units

a48-8563

RUN ELECTRICAL HARNESSES UP THE SIDE OF THE

UNIT IN THE SPACE BETWEEN THE CORNER POST

AND THE CONTROL BOX, THEN ALONGSIDE THE WIRE

TRAY. ROUTE APPROPRIATE WIRES TO

MOTORMASTER AND OFM 1

REMOVE PANEL

RUN TRANSDUCER HARNESS FROM CIRCUIT A

TRANSDUCER TO MOTORMASTER ALONG THE

LENGTH OF THE BOTTOM OF THE CONDENSER COIL

THEN UP INTO MOTORMASTER. RUN THE WIRES

ALONG THE OUTSIDE OF THE COIL TRAY.

MOTORMASTER
CONTROL

Fig. 6 — MMV Control Mounting — 48/50P050-060 Units

a48-8564

This manual is related to the following products: