Exide Technologies Section 92.61 - Manual (Page 10)

NOTE:
1) Straps must be criss-crossed.
2) Lifting shackle orientation and proper channel hole use
must be observed.
3) See Figure 14 for handling modules in horizontal orientation.
4) Never lift more than two joined modules with straps and hooks.
HANDLING - LIFTING STRAP PLACEMENT
Figure 4
SECTION 7
7.0 System Arrangements
7.1 Module Arrangements
Absolyte batteries are recommended for installation in a
horizontal orientation only. However, vertical installation is
approved for 50G systems consisting of single cell modules.
Figures 6 and 7 are typical arrangements and are not intend-
ed to represent all configuration possibilities.
Module stack height limitation depends on cell size and
the seismic requirements of the application. Please refer to
Appendix D for additional information.
- 6 -
CAUTION!
If a fork lift or portable crane is used
to handle modules in a horizontal
position, a piece of insulating mate-
rial such as heavy cardboard, rubber
insulating mats or plywood should be
used between handling equipment and
module tops to prevent shorting of
module top connections with metal
parts of lift equipment.
Figure 6A
Figure 6B
HORIZONTAL SINGLE STACK BACK TO BACK
Figure 6C