2 installation, 1 installation hardware, 2 recommended tools – Unitec C-Start Installation Manual User Manual
Page 9: Installation, Installation hardware, Recommended tools
![background image](/manuals/595555/9/background.png)
C - S T A R T
Document Number: CST1001
5
Document Name: C-Start Installation Manual
2 Installation
2.1 Installation Hardware
Prior to beginning the installation, take the time to verify that all the following required
parts are present and accounted for.
• Key set for door
• Allen Wrench For Door
• (4) Bolts and washers to secure the C -Start terminal to its mounting base.
• (4) Anchor bolts for securing the base to concrete (supplied with base)
Additional parts that may be needed include:
• Shims for leveling the base
• Cable straps (or “Tie Wraps”)
• (2) RJ-45 8 Pin Cable Plugs (for Cat 5 cable termination)
2.2 Recommended Tools
The following tools are recommended for the typical mechanical installation of this C-
Start unit and base:
• Hammer drill with ½” concrete drill bits
• ¾” deep well socket and socket wrench
• Open end 9/16” wrench
• Hammer
• Small, thin blade, flat-tip screwdriver
• Wire Strippers (capable of 10 – 22 AWG wire)
• Modular plug crimp tool (if CAT 5 cable needs to be terminated)
• Diagonal Cutters
• Needle Nose Pliers
• Dual-plane Level