Unitec C-Start Installation Manual - Manual (Page 11)

C - S T A R T
Document Number: CST1001 7
2.4 Mounting the C-Start
1. Rest the C-Start enclosure on top of the base and feed the wires through the
rectangular opening in the bottom the enclosure. This opening is partially
covered by a metal plate which can be slid forward or removed completely to
provide greater access.
2. Align the (4) mounting holes on the bottom of the enclosure with the threaded
inserts on the top of the base. Secure the enclosure to the base with the (4)
bolts and washers supplied with the C-Start unit.
3 Electrical Connections
3.1 General
Before starting, verify all required wires have been routed to the C-Start (as specified
in section 1.2.3). The following figure shows the locations inside the C-Start where
the field wires will connect.
Figure 4. C-Start Interior Connections
Document Name: C-Start Installation Manual