Unitec C-Start Installation Manual - Manual (Page 10)

C - S T A R T
Document Number: CST1001 6
2.3 Base Installation
Note:
Pull all wires through conduits before mounting the base. See Electrical Planning for
wiring requirements.
The C-Start bases are available in (2) heights as shown in the illustration below. This
document describes the procedure for installing the straight base. Angled bases are
also available and they are supplied with a manual addendum (MN1001), which
provides additional instructions.
Figure 3. Straight Bases Dimensions
1. Position the base in place and mark the locations of the (4) mounting holes on
the concrete surface. Remove the base and drill (4) ½” diameter holes, 2” to
2 ½” deep in the marked locations.
2. Insert the anchor bolts (supplied with the base) in these holes and carefully
drive them into place with a hammer. When the anchor bolts have been set,
tighten the nut to secure the bolts in the concrete. Remove the nuts from the
anchor bolts
3. Place the base on the anchor bolts, while ensuring the wires pulled
through the conduit are not pinched under the base. Pull the wires
through the top opening of the base and ensure there is at least 48 inches
of wire draped over the top edge of the base.
4. Place the level on top of the base, and verify its level in both directions
(front to back and side to side). Use shims as needed to level the base.
Once the base is level, place the nuts on the anchor bolts and secure the
base to the concrete.
Document Name: C-Start Installation Manual