Unitec C-Start Installation Manual - Manual (Page 5)

C - S T A R T
Document Number: CST1001 1
1 Site Planning and Preparation
This chapter provides guidelines for positioning the C-Start and preparing the site.
Site preparation includes:
• Determining how and where the C-Start will be mounted
• Installing conduit runs and required wiring
These instructions serve as general guidelines only. If your wash manufacturer’s
installation requirements differ from these guidelines, always meet the wash
manufacturer’s requirements first.
Requirements specified in local electrical and building codes must be followed and
shall take precedence over the guidelines provided within this document. All units
should be installed by a professional electrician ONLY.
The C-Start is rated for the following environmental specifications:
• Temperature: -20° F to 115° F
• Humidity: 0% to 100%
The following ratings label denotes the use of 120V AC power, Single Phase, 8
Amps, and 50-60 Hz, and is used in the C-Start:
The following symbol is used in the C-Start:
This symbol represents the presence of earth-grounded equipment.
This symbol represents the presence of high voltage in the unit.
Document Name: C-Startl Installation Manual