Tweco Victor Torch Handles,Cutting Attachments - Manual (Page 25)

7-21
note:
The above data applies to all torches with the following exceptions:
torch series pre-heat oxygen pre-heat Fuel
MT 200 Series N/A 8 oz. - Up
MT 300 Series 10-50 PSIG 8 oz. - Up
* Applicable for 3-hose machine cutting torches only. With a two hose cutting torch,
preheat pressure is set by the cuttting oxygen.
** For best results use HC1200C and HC1100C series torches and 3/8" hose when using
a size 6 tip or larger.
*** All pressures are measured at the regulator using 25' x 3/8" hose for tip size 6 and
larger.
warning
High gas withdrawal rates require use of a manifold system of sufficient size to
supply the necessary volume. High gas withdrawal rates may also require use
of a vaporizer.
CaUtion
Always make sure your equipment is rated for the size tip you have selected. A tip
with too much capacity for the equipment can starve or choke the tip. This causes
overheating of the head and a backfire may result. Use only genuine VICTOR ® ,
Cutskill ® or Firepower ® cutting tips, welding nozzles and multi-flame nozzles to
ensure leak-free connections and balanced equipment.