Tweco 40mm Cutmaster User Manual

Page 3

WARNING

Read and understand this entire Manual and your employer’s safety practices before installing,

operating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best

judgement, the Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply
CutMaster

40mm

SL100 1Torch™

Operating Manual Number 0-5084

Published by:

Thermal Dynamics Corporation

82 Benning Street

West Lebanon, New Hampshire, USA 03784

(603) 298-5711

www.thermal-dynamics.com

Victor Technologies, Inc

Reproduction of this work, in whole or in part, without written permission of the publisher is

prohibited.

The publisher does not assume and hereby disclaims any liability to any party for any loss or

damage caused by any error or omission in this Manual, whether such error results from negli-

gence, accident, or any other cause.

Publication Date: September 19, 2008

Revision Date: Nov. 30, 2012
Record the following information for Warranty purposes:

Where Purchased:_______________________________ __________________

Purchase Date:__________________________________ __________________

Power Supply Serial #:___________________________ ___________________

Torch Serial #:___________________________________ _________________