Tweco 200 XT Auto-Cut 400V - Manual (Page 48)

AUTO-CUT 200 XT
4-2 OPERATION Manual 0-5284
4.02 Control Console Features
Standard System
PLASMA SHIELD
A
RUN
SET
PLASMA SHIELD
A
RUN
SET
Plasma Gas
Pressure Gauge
Shield Gas
Pressure Gauge
Run / Set Selector
Amperage /
Current
Selector
Plasma Gas Pressure
Control Knob
Shield Gas Pressure
Control Knob
Art # A-11468
Run / Set Selector: Use SET position to adjust plasma and shield pressures and flows. Once these are set, switch
to RUN position for operation.
Plasma and Shield Gas Pressure Control Knobs: Adjust plasma and shield gas pressures. Turn knobs to set
desired levels.
Plasma and Shield Gas Pressure Gauges: Display plasma and shield gas pressures.
Amperage Selector: Continuously adjustable from 5 to 200 Amps. Visible here:
A/
Plasma Gas Type Selector (rear panel): Selects proper operating voltage for either Air & O2 or N2 & H35. Also
use N2/H35 setting for F5.