Tweco 35A CutSkill Power Supply and SL40 Torch EU version - Manual (Page 18)

cutskill 35A
INSTALLATION 3-2 Manual 0-5180
Power Cord and Plug
This power supply comes installed with a input power cable with no plug, Single - Phase input power.
Art # A-09781
230V AC Power Source
Figure 3-1 230V AC Power Source
When the power source input voltage is over or under the safe operating range, the alarm light will turn on, at the
same time the current output will be cut off.
If the power supply voltage continually goes beyond the safe work voltage range it will shorten the power source
life-span.
3.04 Air Supply Connections
A. Connecting Air Supply to Unit
The connection is the same for compressed air or industrial compressed air in gas cylinders.
1. Connect the gas line to the compressed air input inlet port at the appropriate pressure. The illustration shows
typical fittings as an example. (Minimum pressure should be 75 psi/5.2 bar)
NOTE
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions. Do
Not use Teflon tape as a thread sealer, as small particles of the tape may break off and block the small gas
passages in the torch.