Tweco CutMaster 10mm-12mm - Manual (Page 13)

CUTMASTER 10MM, 12MM
Manual 0-5197AC 2-1 SYSTEM INTRODUCTION
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Operating Manual applies to just specifi cation or part
numbers listed on page i. To ensure safe operation, read the
entire manual, including the chapter on safety instructions
and warnings. Throughout this manual, the words WARN-
ING, CAUTION, and NOTE may appear. Pay particular atten-
tion to the information provided under these headings. These
special annotations are easily recognized as follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be purchased by con-
tacting Thermal Dynamics at the address and phone number
in your area listed in the inside back cover of this manual.
Include the Operating Manual number and equipment identi-
fi cation numbers.
Electronic copies of this manual can also be downloaded at
no charge in Acrobat PDF format by going to the Thermal
Dynamics web site listed below and clicking on Thermal
Dynamics and then on the Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identifi cation
The unit’s identifi cation number (specifi cation or part num-
ber), model, and serial number usually appear on a data tag
attached to the rear panel. Equipment which does not have
a data tag such as torch and cable assemblies are identifi ed
only by the specifi cation or part number printed on loosely
attached card or the shipping container. Record these num-
bers on the bottom of page (i) for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for
possible damage due to shipping. If there is any damage, no-
tify the carrier immediately to fi le a claim. Furnish complete
information concerning damage claims or shipping errors to
the location in your area listed in the inside back cover of this
manual.
Include all equipment identifi cation numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before unpacking
the unit. Use care to avoid damaging the equipment when
using bars, hammers, etc., to unpack the unit.
2.04 Working Principle
Rectifier
Inverter Transformer Rectifier
Reduce pressure, filter Gas valve Cutting torch
Workpiece
Compressed air
Art # A-09204_AB