Trebor REV6 - Manual (Page 31)

REV6 OPERATION / MAINTENANCE MANUAL CONTENTS
7 TROUBLESHOOTING
7.1 Troubleshooting for Operation with Standalone Controller
For troubleshooting and failure analysis with the stand-alone controller the following procedure is
recommended:

Check the status of the LEDs. The specific LEDs are described in Table 7

Use the ERROR codes on the display. The specific error codes are described in Table 9

A digital outpu t on the “USER INTERFACE” connector (“Status”) indicates if the system is
active. However, the source of an error cannot be identified by this signal