tekmar 032 Timer - Manual (Page 3)

3 of 4 © 2008 D 032 - 12/08
Step Four: Press and release the Item button. Use the or button to set the event’s
beginning time. If the event is not required, select the “- - : - -” time. This time is
found between 11:50PM and 12:00AM. Record the event time in the schedule
table found at the bottom of this page for future reference.
Repeat step four until all events have been programmed.
OVERRIDING A SCHEDULE
Either a temporary or permanent override can be selected at anytime. A temporary override is in effect for either 3 hours or until a
different override is selected. A permanent override is in effect until a different override is selected. To select an override, use the
following procedure.
Step One: Press and release the Menu button until the Schedule (SCHD) Menu is displayed.
Step Two: Use the or
button to select the desired override.
The timer displays the OVR and Tmpy segments in the display when operating with a temporary override. The OVR and Perm
segments are displayed during a permanent override.
Note: If the None override is selected, the timer uses the programmed schedule.
DISPLAY LIGHTING
The display of the timer has a back light setting. The back lighting can be turned off, turned on or set to operate temporarily for 60
seconds after any button is pressed. To set the operation of the back lighting of the display, use the following procedure.
Step One: Press and release the Menu button until the Time Menu is reached.
Step Two: Press and release the Item button until the word LITE is displayed.
Step Three: Use the or button to select the desired back light operation.
Note: If the back light setting is temporary, the first press of a button turns on the back light.
Event
Occ 1
24 Hour
Schedule Sun Mon Tues Wed Thur Fri Sat
FOUR EVENT SCHEDULE
UnOcc 1
Occ 2
UnOcc 2
Event
Occ
24 Hour
Schedule Sun Mon Tues Wed Thur Fri Sat
TWO EVENT SCHEDULE
UnOcc
Schedules
E01 The timer was unable to read a piece of information stored in its memory. The timer was required to load the factory settings. The
timer will stop operation until all settings are checked. To clear this error, check all of the settings in the timer.
Error Message