Kino Flo Image 85/45 DMX Series - Manual (Page 11)

11
I) DMX-In & DMX-Out: DMX-IN receives DMX signals from Dimmer Board.
DMX-OUT relays DMX signal through to other Fixtures or Instruments.
J)
DMX TERMINATE Switch: Terminates DMX signal at the end of Fixture series.
IMPORTANT!
The dimmer board/light console should have its channel set to LINEAR light output
response. (LINEAR response is the default setting on most dimmer boards.)
Provide 120 Volt AC primary power.
Do not dim the fixture through a dimming circuit.
If powering the fixtures through a dimmer board, set the dimmer profile to non-dim.
Load Considerations:
Kino Flo ballasts are not power factor corrected. They will draw double the current
on the neutral from what is being drawn on the two hot legs. On large installations
it may be necessary to double your neutral run so as not to exceed your cable
capacity.
Manual Operation
The REMOTE jack enables the use of a handheld remote controller
(Accessory Part # DIM-5, see page 17) to turn on lamps.
IMAGE 85 and 45 DMX Fixtures may be operated manually with the Manual
Lamp Selector Dial. The Dial enables you to turn lamps on and off with an
“inside-out” pattern (i.e., if all lamps are on, the outside tubes will turn off first).
The HO/STD switch sets the output level of all the lamps in the fixture. In HO mode
all lamps operate at a High Output level. In STD mode all lamps operate in Standard
light output. There is about a ½ f-stop drop in light in the STD mode.
Power Requirements