E-flite Alpha 450 Sport ARF - Manual (Page 6)

6 E-flite Alpha Sport 450 ARF Assembly Manual
 9. Insert the prebent end of the 4 1 /
2
-inch (114mm)
aileron pushrod in the middle hole of the aileron
control horn. Carefully rotate the aileron pushrod
wire so the middle part of the bend is centered on
the control horn. The pushrod will face the servo as
shown in the last photo of this group.
 10. Use a pin drill and 1/16-inch (1.5mm) drill bit
to enlarge the outer hole of the servo arm that was
removed in Step 1.
 11. Insert the micro pushrod connector in the hole
drilled in the previous step. The connector will be
on the top side of the servo horn.
 12. Slide a micro pushrod connector backplate on
the pushrod connector. Use pliers to fully seat the
backplate in position. Be carefully not to damage the
connector or servo arm by using too much pressure.