E-flite Alpha 450 Sport ARF - Manual (Page 18)

18 E-flite Alpha Sport 450 ARF Assembly Manual
 3. Make sure the rudder trim and stick have been
centered at the transmitter. Position the nose wheel
so it aligned with the sides of the fuselage as
shown in the image below. Tighten the screw at
the rudder servo using a #1 Phillips screwdriver to
secure the nose gear pushrod wire to the connector
at the servo.
If you find your model does not track straight on
the runway, you may need to re-center the nose
wheel. Do not use the rudder trim to correct a
tracking problem with your aircraft. The rudder
trim is used to trim the model in flight.
 4. Make sure the rudder trim and stick have been
centered at the transmitter. Use a ruler to make sure
the rudder is aligned with the fin. Tighten the screw
at the rudder servo using a #1 Phillips screwdriver
to secure the rudder pushrod wire to the connector
at the servo.
 5. Make sure the elevator trim and stick have been
centered at the transmitter. Use a ruler to make sure
the elevator is aligned with the stabilizer. Tighten
the screw using a #1 Phillips screwdriver at the
elevator servo to secure the elevator pushrod wire
to the connector at the servo.
Use threadlock on all metal-to-metal fasteners
to keep them from vibrating loose.