E-flite Alpha 450 Sport ARF - Manual (Page 15)

15 E-flite Alpha Sport 450 ARF Assembly Manual
 6. Insert the bend in the rudder pushrod wire into
the outer hole of the rudder control horn.
 7. Rotate the rudder into position as shown.
 8. Insert the threaded rods from the rudder through
the two forward holes in the stabilizer and into the
holes in the fuselage.
 9. Slide the rudder assembly into position, making
sure it is fully seated on the fuselage as shown.
 10. Slide two 3mm steel washers on the threaded
rods from the rudder assembly. The rudder
assembly is then secured using two 3mm locknuts.
Use a 5.5mm nut driver and a #2 Phillips
screwdriver to tighten the nuts. Make sure not to
over-tighten the nuts and damage the fuselage.