E-flite Alpha 450 Sport ARF - Manual (Page 16)

16 E-flite Alpha Sport 450 ARF Assembly Manual
Installing the Receiver
Required Parts
Fuselage assembly Receiver
Y-harness
Hook and loop tape
Required Tools and Adhesives
Scissors Clear tape
 1. Plug the leads from the rudder servo, elevator
servo and speed control into the appropriate ports
of the receiver. Plug the Y-harness into the aileron
port of the receiver.
 2. Use scissors to cut a small piece of hook and
loop tape. Remove the backing and apply the hook
and loop to the bottom of the receiver.
 3. Remove the remaining backing from the hook
and loop tape. Position the receiver in the fuselage
as shown.
 4. Use clear tape to secure the longer antenna
wire from the receiver under the wing mounting
plate and to the side of the fuselage to keep it from
interfering with the operation of the servos and to
provide the best reception for your radio system.
Installing the Motor Battery
Required Parts
Fuselage assembly Motor battery (charged)
Hook and loop strap Hook and loop tape
 1. Lift up at the rear of the battery hatch and slide
it to the rear of the fuselage to remove. Set the
battery hatch aside to install the motor battery.