E-flite Alpha 450 Sport ARF - Manual (Page 5)

5 E-flite Alpha Sport 450 ARF Assembly Manual
 5. Use pliers to carefully pull the end of the
extension through the large hole that is in the
bottom of the wing. Do not damage the wiring in
the process.
 6. Insert the aileron servo in the rectangular
opening in the wing for the aileron servo. Make
sure the output shaft of the servo faces the training
edge of the wing, which is where the aileron is
hinged. Use a pin drill and 1/6-inch (1.5mm) drill
bit to drill a hole through the tab on the servo and
into the wing. Be careful not to drill through the top
of the wing, damaging the covering.
 7. Remove the servo from the opening. Apply
2–3 drops of thin CA in each hole to harden
the surrounding wood. This will toughen up the
surrounding wood to provide a stronger surface for
the servo mounting screws.
 8. Use the two screws included with the servo to
secure the servo to the wing. You will need to use
a #1 Phillips screwdriver to tighten the screws.
Remember the output of the servo will face the
trailing edge of the wing when placed back in the
rectangular opening for the servo in the wing.