E-flite Rhapsody 25e ARF - Manual (Page 4)

4 E-flite Rhapsody 25e ARF Assembly Manual
Warnings
Read and follow all instructions and safety precautions
before use. Improper use can result in fire, serious
injury and damage to property.
COMPONENTS
Use only with compatible components. Should any
compatibility questions exist please refer to the product
instructions, the component instructions or contact
Horizon Hobby, Inc.
FLIGHT
Fly only in open areas to ensure safety. It is
recommended flying be done at AMA (Academy of
Model Aeronautics) approved flying sites. Consult local
laws and ordinances before choosing a location to fly
your aircraft.
PROPELLER
Keep loose items that can get entangled in the
propeller away from the prop, including loose clothing,
or other objects such as pencils and screwdrivers.
Especially keep your hands away from the propeller as
injury can occur.
BATTERIES
Notes on Lithium Polymer Batteries
When misused, lithium polymer batteries are
significantly more volatile than alkaline or Ni-Cd/
Ni-MH batteries used in RC applications. Always
follow the manufacturer’s instructions when using
and disposing of any batteries. Mishandling of Li-Po
batteries can result in fire and explosion causing
serious injury and damage.
SMALL PARTS
This kit includes small parts and should not be left
unattended near children as choking and serious injury
could result.
SAFETy PRECAUTIONS
This is a sophisticated hobby Product and not a toy.
It must be operated with caution and common sense
and requires some basic mechanical ability. Failure to
operate this Product in a safe and responsible manner
could result in injury or damage to the Product or
other property. This Product is not intended for use by
children without direct adult supervision. The Product
manual contains instructions for safety, operation and
maintenance. It is essential to read and follow all
the instructions and warnings in the manual, prior to
assembly, setup or use, in order to operate correctly
and avoid damage or injury.
During the course of building your Rhapsody 25e we
suggest you use a soft base for the building surface.
Such things as a foam stand, large piece of bedding
foam or a thick bath towel will work well and help
protect the model from damage during assembly.
Rudder and Stabilizer Installation
Required Parts
Stabilizer assembly Fuselage assembly
Fin assembly 4-40 locknut (2)
#4 washer (4)
4-40 x 1/2-inch machine screw (2)
Required Tools and Adhesives
Threadlock Nut driver: 1/4-inch
Thin CA Phillips screwdriver: #1
Make sure to use threadlock on all metal-to-
metal fasteners so they don’t vibrate loose.
 1. Locate the stabilizer and fin assemblies. Insert
the threaded rods on the bottom of the fin into the
holes in the stabilizer. Note the trim scheme of the
stabilizer in the photos.