E-flite 40-Amp Pro Switch-Mode BEC Brushless ESC - Manual (Page 4)

-4-
Troubleshooting
The controller will beep more quietly than normal if the input voltage is
below the cutoff voltage when the battery is connected. Check the voltage
of the battery pack to see if it is correct (charged), or the programmed
cutoff setting if the input voltage is set incorrectly for the voltage of the
pack being used.
If you have trouble arming the controller (and the throttle trim has been
set to minimum), enter the programming mode and try changing the set-
ting to 1.1ms–1.9ms in Programming Menu 4 to see if it helps correct the
problem. If it is a computer radio, you may alternatively increase high and
low throttle ATV (endpoint) percentages.
Note: Increasing the high ATV will not have a consequence on arming
issues, only low ATV.
Some transmitters, including all Futaba transmitters, will require the
throttle channel to be “reversed” for proper operation.
Warranty period
Horizon Hobby, Inc., (Horizon) warranties that the Products purchased
(the “Product”) will be free from defects in materials and workmanship
for a period of 1 year from the date of purchase by the Purchaser.
Limited Warranty
(a) This warranty is limited to the original Purchaser (“Purchaser”) and
is not transferable. REPAIR OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER.
This warranty covers only those Products purchased from an authorized
Horizon dealer. Third party transactions are not covered by this war-
ranty. Proof of purchase is required for warranty claims. Further, Horizon
reserves the right to change or modify this warranty without notice and
disclaims all other warranties, express or implied.
(b) Limitations- HORIZON MAKES NO WARRANTY OR REPRESENTA-
TION, EXPRESS OR IMPLIED, ABOUT NONINFRINGEMENT, MER-
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OF THE
PRODUCT. THE PURCHASER ACKNOWLEDGES THAT THEY ALONE
HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE
REQUIREMENTS OF THE PURCHASER’S INTENDED USE.
(c) Purchaser Remedy- Horizon’s sole obligation here under 8 shall be
that Horizon will, at its option, (i) repair or (ii) replace, any Product
determined by Horizon to be defective. In the event of a defect, these are
the Purchaser’s exclusive remedies. Horizon reserves the right to inspect
any and all equipment involved in a warranty claim. Repair or replacement
decisions are at the sole discretion of Horizon. This warranty does not
cover cosmetic damage or damage due to acts of God, accident, misuse,
abuse, negligence, commercial use, or modification of or to any part of the
Product. This warranty does not cover damage due to improper installa-
tion, operation, maintenance, or attempted repair by anyone other than
Horizon. Return of any goods by Purchaser must be approved in writing
by Horizon before shipment.
Damage Limits
HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CON-
SEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR
COMMERCIAL LOSS IN ANY WAY CONNECTED WITH THE PRODUCT,
WHETHER SUCH CLAIM IS BASED IN CONTRACT, WARRANTY, NEG-
LIGENCE, OR STRICT LIABILITY. Further, in no event shall the liability
of Horizon exceed the individual price of the Product on which liability
is asserted. As Horizon has no control over use, setup, final assembly,
modification or misuse, no liability shall be assumed nor accepted for
any resulting damage or injury. By the act of use, setup or assembly, the
user accepts all resulting liability. If you as the Purchaser or user are not
prepared to accept the liability associated with the use of this Product,
you are advised to return this Product immediately in new and unused
condition to the place of purchase.
Law: These Terms are governed by Illinois law (without regard to conflict
of law principals).
Safety Precautions
This is a sophisticated hobby Product and not a toy. It must be operated
with caution and common sense and requires some basic mechanical
ability. Failure to operate this Product in a safe and responsible manner
could result in injury or damage to the Product or other property. This
Product is not intended for use by children without direct adult supervi-
sion. The product manual contains instructions for safety, operation and
maintenance. It is essential to read and follow all the instructions and
warnings in the manual, prior to assembly, setup or use, in order to
operate correctly and avoid damage or injury.
Questions, Assistance, and Repairs
Your local hobby store and/or place of purchase cannot provide warranty
support or repair. Once assembly, setup or use of the Product has been
started, you must contact Horizon directly. This will enable Horizon to
better answer your questions and service you in the event that you may
need any assistance. For questions or assistance, please direct your email
to [email protected], or call 877.504.0233 toll free to
speak to a service technician.
Inspection or Repairs
If this Product needs to be inspected or repaired, please call for a Return
Merchandise Authorization (RMA). Pack the Product securely using a
shipping carton. Please note that original boxes may be included, but
are not designed to withstand the rigors of shipping without additional
protection. Ship via a carrier that provides tracking and insurance for lost
or damaged parcels, as Horizon is not responsible for merchandise until it
arrives and is accepted at our facility. A Service Repair Request is avail-
able at www.horizonhobby.com on the “Support” tab. If you do not have
internet access, please include a letter with your complete name, street
address, email address and phone number where you can be reached
during business days, your RMA number, a list of the included items,
method of payment for any non warranty expenses and a brief summary of
the problem. Your original sales receipt must also be included for warranty
consideration. Be sure your name, address, and RMA number are clearly
written on the outside of the shipping carton.
Warranty Inspection and Repairs
To receive warranty service, you must include your original sales receipt
verifying the proof-of-purchase date. Provided warranty conditions have
been met, your Product will be repaired or replaced free of charge. Repair
or replacement decisions are at the sole discretion of Horizon Hobby.
Non-Warranty Repairs
Should your repair not be covered by warranty the repair will be completed
and payment will be required without notification or estimate of the
expense unless the expense exceeds 50% of the retail purchase cost. By
submitting the item for repair you are agreeing to payment of the repair
without notification. Repair estimates are available upon request. You
must include this request with your repair. Non-warranty repair estimates
will be billed a minimum of ½ hour of labor. In addition you will be billed
for return freight. Please advise us of your preferred method of payment.
Horizon accepts money orders and cashiers checks, as well as Visa,
MasterCard, American Express, and Discover cards. If you choose to pay
by credit card, please include your credit card number and expiration
date. Any repair left unpaid or unclaimed after 90 days will be considered
abandoned and will be disposed of accordingly. Please note: non-warranty
repair is only available on electronics and model engines.
Electronics and engines requiring inspection or repair should be shipped
to the following address:
Horizon Service Center
4105 Fieldstone Road
Champaign, Illinois 61822
All other Products requiring warranty inspection or repair should be
shipped to the following address:
Horizon Product Support
4105 Fieldstone Road
Champaign, Illinois 61822
Please call 877-504-0233 with any questions or concerns regarding this
product or warranty.
© 2007 Horizon Hobby, Inc.
www.horizonhobby.com
www.E-fliteRC.com
E-flite® is an exclusive brand of Horizon Hobby, Inc.
Made in China
10959.1