E-flite Apprentice 15e RTF with DX5e Radio - Manual (Page 9)

9 E-flite Apprentice Assembly Manual
Landing Gear Installation
Required Parts
Fuselage Assembly Nose gear w/wheel
Main gear w/wheels
Required Tools
Phillips screwdriver: #1
 1. Locate the flat area on the nose gear. This area will be
where the screw will be positioned in the following step.
 2. You will need to back out the screw in the nose wheel
steering arm before sliding in the nose gear wire. Slide
the nose gear into the nose gear bracket. Use a #1
Phillips screwdriver to tighten the screw that secures the
nose gear. Make sure the screw is tightened against the
flat area as indicated in Step 1.
Note: You may need to push the cowling out of the way
slightly to access the screw. The cowl material is flexible
enough to bend a little during this step without damage.