E-flite Apprentice 15e RTF with DX5e Radio - Manual (Page 4)

4 E-flite Apprentice Assembly Manual
Charging the Flight Battery
Your Apprentice can be ready to fly in as little time as it takes
to charge the flight battery. Since this takes approximately 60
minutes, let's get the battery charging right away so it's on
charge while you're assembling your new Apprentice. That way
you can start flying as soon as possible.
Required Parts
Charger
3200 3S 11.1V LiPo battery
Power supply or 12-volt battery (not included)
Note: The battery charger can be connected to a power
supply or 12-volt battery. For the pictures in this manual
we will show the use of a power supply.
 1. Connect the charger to a 12-volt battery or 12-volt
power supply. Connect the red lead to the positive (+)
terminal of the power supply or battery. Connect the
black lead to the negative (-) terminal of the power
supply or 12-volt battery. Once your charger has been
correctly powered up, there will be an approximate
3-second delay and then you will hear an audible “beep”
and the green (ready) LED will flash.