E-flite Apprentice 15e RTF with DX5e Radio - Manual (Page 19)

19 E-flite Apprentice Assembly Manual
 5. Slide the propeller from the propeller adapter. The
installation of the propeller is the reverse of the previous
steps. Make sure the nut is tightened properly so the
propeller does not depart from your model during flight.
Note: Once the radio system has been checked, the
propeller can then be installed. Refer to the section
"Installing the Propeller" later in this manual for details.
Control Functions
Required Parts
Transmitter
 The following images to identify the controls for both the
Mode 1 and Mode 2 versions of your Apprentice.
Elevator/Rudder Stick
Throttle/Aileron Stick
Reversing Switches Mix Switch (not used for Apprentice)
Elevator Trim
Rudder Trim
Aileron Trim
Throttle Trim
HI/LO
Rate Switch
Mode 1 Transmitter