E-flite Apprentice 15e RTF with DX5e Radio - Manual (Page 33)

33 E-flite Apprentice Assembly Manual
 2. Plug the motor battery into the speed control.
Important: Always use extreme caution around the
propeller when the motor battery is plugged in. A
spinning propeller can cause serious damage or injury.
It is always best to stay behind the propeller and keep
it away from loose objects when the battery and speed
control are connected.
Elevator Throw
 3. Use a ruler to check the control throws on your
elevator. The dimensions are shown below. For your
reference the elevator pushrod is set up in the following
holes: The outside hole on the elevator control horn and
the fourth hole in on the elevator servo arm.
Low Rate: 3/8-inch (9mm) (Up/Down)
High Rate: 3/4-inch (19mm) (Up/Down)