E-flite Apprentice 15e RTF with DX5e Radio - Manual (Page 13)

13 E-flite Apprentice Assembly Manual
 7. Connect the aileron pushrod clevis to the aileron
control horn in the hole that is farthest away from the
aileron. Make sure to slide the silicone retainer onto the
clevis to keep the clevis from popping off of the control
horn. Connect both the right and left aileron linkages at
this time.
 8. Connect the wires from the aileron servos to the
Y-harness coming from the receiver.
 9. Install the first two rubber bands. They should cross as
shown in the image below.
 10. The next two rubber bands will go directly from the
front to the rear of the fuselage, over the wing.