E-flite Leader 480 - Manual (Page 16)

16 E-flite Leader 480 ARF Assembly Manual
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 6. Use two 2.5mm wheel collars to secure the 51mm
foam wheel to the landing gear. The setscrews are
tightened using a 1.5mm hex wrench.
 7. Repeat steps 1 through 6 to install the remaining
landing gear and wheel.
Wing Installation
Required parts
Wing panel with aileron (left and right)
Aluminum wing tube
3mm x 10mm socket head cap screw (4)
3mm washer (4)
Required Tools and Adhesives
Hex wrench: 2.5mm
 1. Slide the aluminum wing tube into the socket in
the wing panel. The tube will slide in easily, so do not
force it in any farther than it will easily slide.
 2. Slide the tube into the socket in the fuselage. Make
sure to guide the lead for the aileron servo in the
fuselage when positioning the wing.
 3. Use two 3mm x 10mm socket head cap screws
and two 3mm washers to secure the position of the
wing. Use a 2.5mm hex wrench to tighten the screws.
Plug the aileron servo into the receiver if you are
preparing your model for flight.
 4. Repeat step 3 to install the second wing panel.