E-flite Ultimate 3D Profile ARF - Manual (Page 6)

6 7
Before Starting Assembly
Before beginning the Assembly of your Ultimate or
Tribute, remove each part from its bag for inspection.
Closely inspect the fuselage, wing panels, rudder
and stabilizer for damage. If you find any damaged
or missing parts, contact the place of purchase.
Using the Manual
This manual is divided into sections to help make
assembly easier to understand, and to provide
breaks between each major section.
Remember to take your time and follow the
directions.
Introduction
The Tribute and Ultimate encompass the latest
developments in small 3D Aerobatic Electric design.
These designs are meant to serve as both an
advanced trainer for those interested in learning
3D-aerobatics, while also being a tool to keep
the proficient pilot sharp during the off-season
by allowing 3D-style aerobatics to be flown in a
controlled indoor or low wind outdoor environment.
Special consideration was given to insure flight
speeds that could be comfortably flown in a standard
size gymnasium. Once the pilot becomes proficient at
hovering-flight, it is possible to fly the model in very
confined spaces such as a garage or living room.
The included 370 motor is designed for 2-cell use.
For extreme 3D aerobatics and extended hovering it
is recommended to upgrade to a brushless motor.
Please note that once assembly of the model has
been started, you must contact Horizon Hobby, Inc.
directly regarding any warranty question. Please
do not contact your local hobby shop regarding
warranty issues, even if that is where you purchased
it. This will enable Horizon to better answer your
questions and service you in the event that you may
need any assistance.
If the buyer is not prepared to accept the liability
associated with the use of this product, the buyer
is advised to return this kit immediately in new and
unused condition to the place of purchase.
Horizon Hobby, Inc.
4105 Fieldstone Road
Champaign, Illinois 61822
(877) 504-0233
www.horizonhobby.com
Warranty Information
Horizon Hobby, Inc. guarantees this kit to be free
from defects in both material and workmanship at the
date of purchase. This warranty does not cover any
component parts damage by use or modification. In
no case shall Horizon Hobby’s liability exceed the
original cost of the purchased kit. Further, Horizon
Hobby reserves the right to change or modify this
warranty without notice.
In that Horizon Hobby has no control over the final
assembly or material used for the final assembly,
no liability shall be assumed nor accepted for any
damage resulting from the use of the final assembled
product. By the act of using the assembled product,
the user accepts all resulting liability.