E-flite Ultimate 3D Profile ARF - Manual (Page 25)

25
Ultimate Aileron Connection
Linkage
Required Parts
Airframe Control horn (4)
Control horn back plate (4) Aileron wire
Micro pushrod keeper (4)
Required Tools and Adhesives
Pliers
❍ 1. Locate two control horns and two control
horn back plates. Install one control horn
in the top aileron, the other in the bottom
aileron. The horns will face each other when
installed.
Hint: Use tape to hold the ailerons at neutral
while installing the linkages.
24
❍ 5. Center the aileron servo and aileron. Tighten
the screw on the connector to secure the
pushrod wire.
❍ 6. Repeat Steps 1 through 5 for the remaining
aileron servo.