E-flite Ultimate 3D Profile ARF - Manual (Page 11)

11
❍ 3. Use foam-safe CA to glue the stabilizer into
the fuselage.
❍ 4. Use foam-safe CA to glue the elevator to the
balsa elevator joiner. Use the included clear
tape on the top and bottom of the hinge line
to complete the elevator installation.
10
Stabilizer Installation
Required Parts
Stabilizer Fuselage
Clear tape
Required Tools and Adhesives
Square Foam-safe CA
❍ 1. Locate the stabilizer and remove the elevator
that is not hinged to the stabilizer. Measure
and draw a centerline on the stabilizer.
❍ 2. Slide the stabilizer into the slot in the
fuselage. Use a square to check the
alignment of the stabilizer as shown.