E-flite Tribute FX 3D ARF - Manual (Page 18)

18 E-flite Tribute Fx 3D ARF Assembly Manual
Motor Installation
Required Parts
Airframe Cowling
Brushless motor Outrunner stick mount w/hardware
Electronic speed control 1.5mm x 10mm sheet metal screw
Hook and loop tape 2mm x 6mm sheet metal screw (4)
Spinner Spinner backplate
Motor adapter 1/2 in (13mm) washer
Required Tools and Adhesives
Phillips screwdriver Drill
Drill bit: 1/16 in (1.5mm) Cardstock
Low-tack tape
 1. Mount your particular motor to the outrunner stick mount
using the hardware provided with the mount. There are
spacers provided with the mount to use with the E-flite
Park 450 Outrunner, which has the collar on the back of
the motor.
 2. Plug the motor leads into the electronic speed control.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also,
be sure to use an ESC with the proper 9V cutoff when
using 3-cell Li-Po packs, or 6V cutoff when using 2-cell
Li-Po packs.